English
-
2023-02-22Horizontal Injection Molding Machine
1. Even if the mainframe is low, there is no height limit for the factory building.2. Where the product can be dropped automatically, automatic forming can be realized without the use of manipulators.
-
2023-02-22Features of Vertical Injection Molding Machine
1. The injection device and the clamping device are on the same vertical center line, and the mold is opened and closed along the up and down direction. Its floor area is only about half of that of th
-
2023-02-22Classification Of Injection Molding Machines
1) Classified by plasticizing method1. Plunger Plastic Injection Molding MachineIts mixing performance is very poor, and its plasticizing property is not good, so a shunt shuttle device should be inst
-
2023-02-22Energy Saving and Consumption Reduction of Injection Molding Machines
The energy saving of the injection molding machine can be divided into two parts: one is the power part and the other is the heating part.Energy saving in the power part: Most of them use frequency co
-
![Working Principle Of Injection Molding Machine]()
2023-02-22Working Principle Of Injection Molding Machine
The working principle of the injection molding machine is similar to the syringe used for injection. It uses the thrust of the screw (or plunger) to inject the plastic that has been plasticized into t
